Header

by: Wabbit41

This was very easy to do! No cutting/splicing involved. All you need is a large Phillips head screwdriver to mount the ground wire.

Now I have tested this. With all the prongs set to 'off' (up position) the signals cancel after 10 blinks, or about 8 seconds. Unlike a real turn signal canceller, if you are going to make successive right or left turns you have to click the turn signal indicator before retrying another successive turn in the same direction. Install time? About 10 minutes.

Make sure you connect the ground wire directly to battery ground or it may not work correctly. The brake delay is not a separate wire. It's the red wire in the three wire harness that comes with the kit.

Copyright © 2003-2005, FZ1 Owners Association, All Rights Reserved.

The marks YAMAHA® and FZ1® are used under license from Yamaha Motor Corporation, U.S.A.
The information on this web site is NOT approved or endorsed by Yamaha Motor Corporation in any way.

The information contained here is for entertainment purposes only. No information presented here is to be relied upon for issues of rider safety nor to replace the services of a qualified service technician. Any attempts to follow or duplicate any of these procedures are done so completely at your own risk. By reading the information on this site, you agree to assume complete responsibility for any and all actual or consequential damages that may arise from any information presented herein.